84340
1.INSPECT STOP LIGHT SWITCH ASSEMBLY
| *a | Component without harness connected
(Stop Light Switch Assembly) |
| *b | Shaft |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A27-1 - A27-2 | Shaft not pushed | 10 kΩ or higher |
| Shaft pushed | Below 1 Ω | |
| A27-3 - A27-4 | Shaft not pushed | Below 1 Ω |
| Shaft pushed | 10 kΩ or higher |
If the result is not as specified, replace the stop light switch assembly.