Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL
RM33J0E _54 Brake _038478 BRAKE SYSTEM (OTHER) _0189452 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

Hide 55106 2.INSTALL BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.

Install the nut to the brake pedal support sub-assembly.


b.

Install the brake pedal support sub-assembly with the 4 nuts.

Torque:
18.4 N*m (188 kgf*cm, 14 ft.*lbf)


c.

Install the brake pedal support reinforcement set bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


d.

Attach the 2 clamps to the brake pedal support sub-assembly.


e.

Connect the connector to the stop light switch assembly.


Hide 47264A 3.INSTALL PUSH ROD PIN

a.
C143749C02
2.281,0.302 2.438,0.5 0.156,0.198 10 .
V100145

Lithium soap base glycol grease


Apply a light coat of lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support sub-assembly.


b.

Set the push rod clevis in place, insert the push rod pin from inside the vehicle, and then attach a new clip.

NOTICE:

After installation, check that the pedal operates smoothly.



Hide 47101A 4.INSTALL BRAKE PEDAL RETURN SPRING

a.

Install the brake pedal return spring to the brake pedal support sub-assembly and push rod pin.


Hide 5.CHECK AND ADJUST BRAKE PEDAL HEIGHT

Hide 55302A 6.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION