Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM33J0E _54 Brake _038478 BRAKE SYSTEM (OTHER) _0189453 BRAKE MASTER CYLINDER G

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  INSPECTION  


PROCEDURE

Hide 1.INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

NOTICE:

Make the adjustment with no vacuum in the brake booster assembly. (Depress the brake pedal several times with the engine stopped.)


HINT:
·

Adjustment of the brake booster push rod is required when the brake master cylinder sub-assembly is replaced with a new one.

·

Adjustment is not necessary when the removed brake master cylinder sub-assembly is reused and the brake booster assembly is replaced with a new one.



a.

Apply chalk to the tip of the accessory tool.

HINT:

An accessory tool is included with a new brake master cylinder sub-assembly.



b.
C132707C15
0.75,0.99 1.25,0.135 true 0.51,1.177 0.958,1.948 true 1.271,0.021 1.458,0.177 0.188,0.156 10 false *a 0.979,1.938 1.146,2.104 0.167,0.167 10 false *1
*1 Accessory Tool
*a Apply Chalk


Place the accessory tool on the brake booster assembly.


c.

Measure the clearance between the brake booster push rod and accessory tool.

Standard clearance:

0 mm (0 in.)


HINT:

Adjust the clearance in the following cases:

·

If there is a clearance between the accessory tool and the shell of the brake booster (floating accessory tool), the push rod is protruding too far.

·

If the chalk does not stick on the tip of the brake booster push rod, the push rod protrusion is insufficient.




d.
C128539N05
1.917,1.667 1.406,1.156 true 1.917,1.667 2.167,1.667 false 2.25,1.594 2.667,1.792 0.417,0.198 10 false SST

If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver.

SST
09737-00020  

NOTICE:

Check the push rod clearance again after adjustment.