Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM SWITCHING VALVE(for 2TR-FE, 2TR-FBE)
RM33J0E _54 Brake _038478 BRAKE SYSTEM (OTHER) _0189456 VACUUM SWITCHING VALVE(for 2TR-FE) G

BRAKE SYSTEM (OTHER)  VACUUM SWITCHING VALVE(for 2TR-FE)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17650G 1.INSPECT DUTY VACUUM SWITCHING VALVE

a.
C334201

Slide the clip and disconnect the air hose (connected to the air cleaner hose) from the duty vacuum switching valve.


b.

Move the shift lever to neutral and apply the parking brake.


c.

Connect the GTS to the DLC3, and then turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Brake Ejector VSV Inspection.

Powertrain > Engine and ECT > Active Test
Tester Display
Brake Ejector VSV Inspection
50004 234 249

f.

Start the engine.


g.

Using the GTS, turn off the duty vacuum switching valve.


h.
C334202

Use your finger to confirm that the duty vacuum switching valve has no suction.


i.

Using the GTS, turn on the duty vacuum switching valve.


j.

Use your finger to confirm that the duty vacuum switching valve has suction.


k.

Turn the GTS off and turn the ignition switch off.


l.

Disconnect the GTS from the DLC3.


m.

Connect the air hose to the duty vacuum switching valve and slide the clip to secure it.