Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM SWITCHING VALVE(for 2TR-FE, 2TR-FBE)
RM33J0E _54 Brake _038478 BRAKE SYSTEM (OTHER) _0189456 VACUUM SWITCHING VALVE(for 2TR-FE) G

BRAKE SYSTEM (OTHER)  VACUUM SWITCHING VALVE(for 2TR-FE)  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

a.

Check the No. 1 vacuum switching valve assembly for an open circuit.

i.
A128939C01
1.831,0.87 1.968,1.033 0.137,0.163 10 2 1.473,2.029 1.604,2.182 0.131,0.153 10 1 1.566,1.597 1.858,1.057 false 1.532,1.694 1.533,2.021 false 1.488,4.264 1.619,4.417 0.131,0.153 10 1 1.537,3.997 1.54,4.266 false 1.819,3.188 1.956,3.351 0.137,0.163 10 2 1.555,3.916 1.847,3.376 false 0.147,0.095 0.313,0.245 0.166,0.15 10 *a 0.147,2.224 0.313,2.375 0.166,0.15 10 *a
*a Component without harness connected
(No. 1 Vacuum Switching Valve Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - Body ground Always 10 MΩ or higher
2 - Body ground Always 10 MΩ or higher


If the result is not as specified, replace the No. 1 vacuum switching valve assembly.



b.
C201792N01
1.135,1.125 1.135,1.552 false 2.021,1.313 2.021,1.552 false 1.979,1.573 2.313,1.875 0.333,0.302 10 false E 1.094,1.573 1.375,1.802 0.281,0.229 10 false F

Check the operation of the No. 1 vacuum switching valve assembly.

i.

Check that air does not flow from the port (E) to port (F) as shown in the illustration.

If the result is not as specified, replace the No. 1 vacuum switching valve assembly.


ii.
C201793N01
0.625,0.719 0.625,1.188 false 1.385,0.844 1.385,1.188 false 0.594,1.198 0.896,1.479 0.302,0.281 10 false F 1.344,1.198 1.688,1.635 0.344,0.438 10 false E

Apply battery voltage between the terminals.


iii.

Check that air flows from the port (E) to port (F) as shown in the illustration.

If the result is not as specified, replace the No. 1 vacuum switching valve assembly.