Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
for Type A:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION
for Type B:
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55302A
3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
89741
4.REMOVE DOOR CONTROL RECEIVER (w/o Smart Entry and Start System)
|
Nut |
|
Connector |
Remove the nut.
Detach the guide and remove the door control receiver.
Disconnect the connector.
89740A
5.REMOVE SMART DOOR CONTROL RECEIVER ASSEMBLY (w/ Smart Entry and Start System)
|
Nut |
|
Connector |
Remove the nut.
Detach the guide and remove the smart door control receiver assembly.
Disconnect the connector.