Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM33J0E _59 Vehicle Exterior _038507 WINDOW / GLASS _0189850 POWER WINDOW CONTROL SYSTEM D

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  OPERATION CHECK  


CHECK WINDOW LOCK FUNCTION


E296989

a.

w/ Smart Entry and Start System or w/o Jam Protection Function

i.

Turn the ignition switch to ON.


ii.

Press the window lock switch of the power window regulator master switch assembly.

HINT:

The illumination (LED) built into the switch knob of each seat does not turn off.



iii.

Check that the power window for each seat except the driver seat can no longer be operated.


iv.

When the window lock switch is pressed again, check that the power window for each seat except the driver seat can be operated.



b.

for Models with Jam Protection Function on Driver Door Window Only

i.

Turn the ignition switch to ON.


ii.

Press the window lock switch of the power window regulator master switch assembly.

HINT:

The illumination (LED) built into the switch knob of each seat does not turn off.



iii.

Check that the power window for each seat except the driver seat can no longer be operated.


iv.

Check that the power window for each seat cannot be operated from the driver seat.


v.

Press the window lock switch of the power window regulator master switch assembly again.


vi.

Check that the power window for each seat except the driver seat can be operated.


vii.

Check that the power window for each seat can be operated from the driver seat.




CHECK MANUAL UP / DOWN FUNCTION


a.

Check that the driver door power window operates as follows:

OK
Condition Master Switch Switch Operation Power Window
Ignition switch ON Driver door Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)


b.

Check that the front passenger door window and rear power windows* operate as follows:

*: for Double Cab


OK
Condition Regulator Switch Switch Operation Power Window

*: for Double Cab

·

Ignition switch ON

·

Window lock switch off


Front passenger door Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)
Rear LH door* Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)
Rear RH door* Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)



CHECK AUTO UP / DOWN FUNCTION (w/ Jam Protection Function)


*: w/ Smart Entry and Start System


a.

Check that the driver door power window operates as follows:

OK
Condition Master Switch Switch Operation Power Window
·

Ignition switch ON

·

Window lock switch off


Driver door Pulled up (One touch operation) AUTO UP (Closes)
Pushed down (One touch operation) AUTO DOWN (Opens)


b.

Check that the front passenger door window and rear power windows operate as follows*:

OK
Condition Regulator Switch Switch Operation Power Window
·

Ignition switch ON

·

Window lock switch off


Front passenger door* Pulled up (One touch operation) AUTO UP (Closes)
Pushed down (One touch operation) AUTO DOWN (Opens)
Rear LH door* Pulled up (One touch operation) AUTO UP (Closes)
Pushed down (One touch operation) AUTO DOWN (Opens)
Rear RH door* Pulled up (One touch operation) AUTO UP (Closes)
Pushed down (One touch operation) AUTO DOWN (Opens)



CHECK AUTO DOWN FUNCTION (w/o Jam Protection Function)


a.

Check that the driver door power window operates as follows:

OK
Condition Master Switch Switch Operation Power Window
Ignition switch ON Driver door Pushed down (One touch operation) AUTO DOWN (Opens)



CHECK REMOTE MANUAL UP / DOWN FUNCTION


*: for Double Cab


a.

Check that the front passenger door window and rear power windows* operate as follows:

OK
Condition Master Switch Switch Operation Power Window
Ignition switch ON Front passenger door Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)
Rear LH door* Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)
Rear RH door* Pulled halfway up UP (Closes)
Pushed halfway down DOWN (Opens)



CHECK REMOTE AUTO UP / DOWN FUNCTION (w/ Smart Entry and Start System)


a.

Check that the front passenger door window and rear power windows operate as follows:

OK
Condition Master Switch Switch Operation Power Window
Ignition switch ON Front passenger door Pulled up (One touch operation) AUTO UP (Closes)
Pushed down (One touch operation) AUTO DOWN (Opens)
Rear LH door Pulled up (One touch operation) AUTO UP (Closes)
Pushed down (One touch operation) AUTO DOWN (Opens)
Rear RH door Pulled up (One touch operation) AUTO UP (Closes)
Pushed down (One touch operation) AUTO DOWN (Opens)



CHECK KEY-OFF OPERATION FUNCTION (w/ Jam Protection Function)


a.

w/ Smart Entry and Start System

i.

Check that each power window can be operated with the power window regulator master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly* after the ignition switch is turned off.

HINT:

If the window lock switch is on, the power windows cannot be operated by using the power window regulator switch assembly and rear power window regulator switch assembly*. Therefore, turn the window lock switch off before checking the window operation.


*: for Double Cab



ii.

Check that the key-off operation function does not operate immediately after the driver door or front passenger door is opened.

HINT:

Even if the driver door or passenger door is opened during automatic window operation while the key-off operation function is on, the window will continue operating.



iii.

Check that all the power windows cannot be operated after more than approximately 43 seconds have elapsed since the ignition switch is turned off.



b.

for Models with Jam Protection Function on Driver Door Window Only

i.

Check that driver door power window can be operated with the power widow regulator master switch assembly after the ignition switch is turned off.

HINT:

If the window lock switch is on, the power windows cannot be operated by using the power window regulator switch assembly and rear power window regulator switch assembly*. Therefore, turn the window lock switch off before checking the window operation.


*: for Double Cab



ii.

Check that the key-off operation function does not operate immediately after the driver door or front passenger door is opened.

HINT:

Even if the driver door or passenger door is opened during automatic window operation while the key-off operation function is on, the window will continue operating.



iii.

Check that all the power windows cannot be operated after more than approximately 43 seconds have elapsed since the ignition switch was turned off.




CHECK JAM PROTECTION FUNCTION (w/ Jam Protection Function)


a.

Check the basic function.

CAUTION:

Do not put your fingers between the door frame and door glass to check the jam protection function. Also, prevent any part of your body from being caught during inspection.


HINT:

The jam protection function is operative during both the auto up and manual up operations while the engine is running or the ignition switch is ON, and also for approximately 43 seconds after the ignition switch is turned off.


i.

Fully open all door windows.


ii.
B274528C11
1.646,0.208 1.885,0.208 1.885,0.208 1.885,0.781 false 2.25,0.208 2.135,0.208 2.135,0.208 2.135,0.708 false 1.448,0.115 1.625,0.271 0.177,0.156 10 *a 2.281,0.115 2.458,0.271 0.177,0.156 10 *b
*a Check Jig
*b Cloth


Set a check jig wrapped with a piece of cloth near the window fully closed position.


iii.

When an auto up or manual up operation is performed to fully close the door glass, check that the glass stops momentarily when it contacts the end of the hammer, lowers via a down operation and then stops.

HINT:
·

If a manual up operation is performed from the seat, the door glass will lower approximately 30 mm (1.181 in.) from the point it contacts the end of the hammer or continue lowering for approximately 5 seconds and then stop.

·

If a manual up operation is not performed from the seat, the door glass will lower approximately 125 mm (4.921 in.) from the point it contacts the end of the hammer or continue lowering for approximately 5 seconds and then stop.

·

After the jam protection function operates when an auto up or manual up operation is performed, the jam protection function will not operate when the manual up operation is performed again within approximately 4 seconds.

·

After the catch protection function operates when an auto down or manual down operation is performed, the jam protection function will not operate when the manual up operation is performed again within approximately 4 seconds.




iv.

While the door glass is lowering, check that the switch of that door or the remote operation using the power window regulator master switch assembly cannot be used to raise the door glass.




CHECK CATCH PROTECTION FUNCTION (w/ Catch Protection Function)


a.
B367854

Check the basic operation.

HINT:

The catch protection function is operative during both the auto down and manual down operations while the engine is running or the ignition switch is ON, and also for approximately 43 seconds after the ignition switch is turned off.


i.

Fully close all door windows.


ii.

While using auto down or manual down to open the window, grasp the upper edge of the door glass with one or two hands and check that the door glass operation stops.

HINT:

After the catch protection function operates when an auto down or manual down operation is performed, the catch protection function will not operate when the manual down operation is performed again within approximately 4 seconds.





CHECK POWER WINDOW SWITCH LED ILLUMINATION


a.

When the ignition switch is turned from off to ON with the connectors connected, check that the illumination (LED) on the switch portion of the power window regulator switch assembly turns on.

B377796E04
4.802,0.823 4.99,0.219 4.99,0.219 5.281,0.219 false 0.25,0.104 2.031,0.385 1.781,0.281 12 false Normal output pattern: 5.333,0.156 7.104,0.385 1.771,0.229 10 false Approximately 43 seconds 2.125,0.667 2.896,0.865 0.771,0.198 10 false IG ON 2.073,1.188 2.99,1.385 0.917,0.198 10 false IG OFF 1.844,1.656 2.625,1.854 0.781,0.198 10 false Permission 1.927,2.125 2.646,2.323 0.719,0.198 10 false Prohibition 2.271,2.667 2.583,2.865 0.313,0.198 10 false On 2.26,3.146 2.573,3.344 0.313,0.198 10 false Off 2.281,3.542 2.594,3.74 0.313,0.198 10 false On 2.292,3.969 2.75,4.167 0.458,0.198 10 false Off 0.24,0.875 1.615,1.073 1.375,0.198 10 false Ignition switch 0.229,1.854 1.458,2.052 1.229,0.198 10 false Key-off operation 0.25,2.865 1.479,3.063 1.229,0.198 10 false LED 0.229,3.76 2.375,3.958 2.146,0.198 10 false Window lock switch signal