Bore all 4 cylinders to fit the O/S piston outside diameter.
Replace all the piston rings with ones to match the O/S pistons.
1.BORE CYLINDER
Prepare 4 new O/S pistons.
| *a | Distance |
Using a micrometer, measure the piston diameter at right angles to the piston center line where the distance from the piston end is as specified.
95.471 to 95.481 mm (3.7587 to 3.7591 in.)
13.8 mm (0.543 in.)
Calculate the amount each cylinder is to be rebored as follows.
| P | Piston diameter |
| C | Piston oil clearance: 0.009 to 0.048 mm (0.000354 to 0.00189 in.) |
| H | Allowance for honing: 0.02 mm (0.000787 in.) or less |
Bore and hone the cylinders to the calculated dimensions.
0.02 mm (0.000787 in.)
Excess honing will destroy the finished roundness.
Using a cylinder gauge, measure the cylinder bore diameter and calculate the honing allowance.
Honing allowance = cylinder bore diameter - (piston diameter + oil clearance)
Finish the cylinder bore using the calculated value.
| *a | Thrust Direction |
| *b | Axial Direction |
| *c | 10 mm (0.394 in.) |
| *d | 70 mm (2.75 in.) |
|
Front |
Using a cylinder gauge, measure the cylinder bore diameter.
0.009 to 0.048 mm (0.000354 to 0.00189 in.)