This circuit is from the parking brake switch assembly to the radio and display receiver assembly.
Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check.
Check that the display changes between ON and OFF according to the parking brake operation.
| Parking Brake Condition | Display |
|---|---|
| Applied | ON |
| Released | OFF |
This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the parking brake switch assembly.
Inspect the parking brake switch assembly.
Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G37 radio and display receiver assembly connector.
Disconnect the N5 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-15 (PKB) - N5-1 | Always | Below 1 Ω |
| G37-15 (PKB) or N5-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG