The combination meter assembly sends an auto dimmer signal to the radio and display receiver assembly via this circuit.
When the radio and display receiver assembly receives an auto dimmer signal from the combination meter assembly, the panel switch of the radio and display receiver assembly dims and the screen changes to the night screen.
When replacing the combination meter assembly, make sure to replace it with a new one.
Disconnect the radio and display receiver assembly connector.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-3 (ADIM) - Body ground | Ignition switch ON, automatic light control sensor covered by hand, and light control switch in tail or head position | 11 to 14 V |
| Ignition switch ON, automatic light control sensor not covered by hand, and light control switch in auto position | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G37 radio and display receiver assembly connector.
Disconnect the G9 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-3 (ADIM) - G9-4 (ACAN) | Always | Below 1 Ω |
| G37-3 (ADIM) or G9-4 (ACAN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG