Home › Engine / Hybrid System › 2GD-FTV COOLING › THERMOSTAT
RM33J0E _51 Engine / Hybrid System _038442 2GD-FTV COOLING _0191908 THERMOSTAT A

2GD-FTV COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.
A341325C01
0.76,1.135 1.01,1.135 false 2.417,1.198 2.667,1.198 false 1.094,0.531 1.406,0.729 0.313,0.198 10 false *a 2.198,0.521 2.51,0.719 0.313,0.198 10 false *b 0.594,1.063 0.906,1.26 0.313,0.198 10 false *1 2.719,1.115 3.031,1.313 0.313,0.198 10 false *1
*1 Gasket
*a CORRECT
*b INCORRECT


Install a new gasket to the thermostat.

NOTICE:

When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat as shown in the illustration.



b.
A341232C01
1.74,0.688 2.24,0.688 true 1.938,0.344 2.104,0.094 2.104,0.094 2.271,0.094 true 1.5,0.354 1.333,0.104 1.333,0.104 1.167,0.104 true 2.292,0.594 2.583,0.833 0.292,0.24 10 true *c 1.625,0.021 1.844,0.219 0.219,0.198 10 true *a 2.292,0.021 2.51,0.219 0.219,0.198 10 true *b 0.969,0.031 1.188,0.229 0.219,0.198 10 true *b
*a Upward
*b 30°
*c Jiggle Valve


Insert the thermostat into the engine water pump assembly with the jiggle valve facing straight upward.

HINT:

The jiggle valve may be set to within 30° on either side of the prescribed position.



Hide 16321 2.INSTALL WATER INLET

a.

Install the water inlet with the 3 bolts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 16572D 3.CONNECT NO. 2 RADIATOR HOSE

a.

Connect the No. 2 radiator hose to the water inlet and slide the hose clamp to secure the hose.


b.

Connect the suction hose sub-assembly to the water inlet with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 16207 4.CONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY

a.

Connect the No. 2 water by-pass pipe sub-assembly to the engine water pump assembly and water inlet with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)