Home › Engine / Hybrid System › 1KD-FTV STARTING › STARTER(for 2.0 kW Type)
RM33J0E _51 Engine / Hybrid System _038435 1KD-FTV STARTING _0191923 STARTER(for 2.0 kW Type) A

1KD-FTV STARTING  STARTER(for 2.0 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

for Automatic Transmission:

i.
A343739N01
3.021,0.542 3.177,0.74 0.156,0.198 10 true A 2.823,1.531 2.979,1.729 0.156,0.198 10 true B

Temporarily install the starter assembly and ground cable with the nut and 2 bolts.


ii.

Tighten the bolt A and nut B.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



b.

for Manual Transmission:

i.

Temporarily install the starter assembly and ground cable with the 2 bolt.


ii.

Tighten the 2 bolts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



c.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the starter connector.


e.

Install the starter terminal cap.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 53882K 3.INSTALL FRONT FENDER SEAL LH

a.

Install the front fender seal LH with new 6 clips.


Hide 51442 4.INSTALL NO. 2 ENGINE UNDER COVER

Hide 51410 5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION