Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
88625
1.INSTALL NO. 1 COOLER THERMISTOR (FRONT EVAPORATOR TEMPERATURE SENSOR)
Install the No. 1 cooler thermistor (front evaporator temperature sensor) as shown in the illustration.
Be sure to insert the No. 1 cooler thermistor (front evaporator temperature sensor) only once because reinserting it into the same position will not allow it to be firmly secured.
When reusing the evaporator, insert the No. 1 cooler thermistor (front evaporator temperature sensor) one row next to the one that has been used previously.
After inserting the thermistor, do not apply excessive force to the wire.
| Position | Measurement |
|---|---|
| a | 45 to 55 mm (1.78 to 2.16 in.) |
| b | 61.1 mm (2.41 in.) (9 Fins) |
88501
2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88515
3.INSTALL COOLER EXPANSION VALVE
87107A
4.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
88650N
5.INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY
82210K
6.INSTALL AIR CONDITIONING HARNESS ASSEMBLY (for Automatic Air Conditioning System)
87130D
7.INSTALL BLOWER ASSEMBLY
8.INSTALL AIR CONDITIONING UNIT ASSEMBLY