Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2015.06–2015.11
RM33J0E _59 Vehicle Exterior _038498 LIGHTING (EXT) _0192387 LIGHTING SYSTEM Y

LIGHTING (EXT)  LIGHTING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the lighting system.

·

*: Use the GTS



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

3.CHECK VEHICLE TYPE
3.CHECK VEHICLE TYPE
a.

Check the vehicle type.


Result:
Result Proceed to
w/ VSC A
w/o VSC B



A

4.CHECK VEHICLE STABILITY CONTROL SYSTEM*

B

11.CHECK ANTI-LOCK BRAKE SYSTEM
4.CHECK VEHICLE STABILITY CONTROL SYSTEM*
a.

Use the GTS to check if the vehicle stability control system is functioning normally.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B



A

5.CHECK METER/GAUGE SYSTEM*

B

5.CHECK METER/GAUGE SYSTEM*
a.

Use the GTS to check if the meter/gauge system is functioning normally.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR

Body Electrical > Combination Meter > Trouble Codes
50001 122

Result:
Result Proceed to
Meter/gauge system DTCs are not output A
Meter/gauge system DTCs are output B



A

6.CHECK CAN COMMUNICATION SYSTEM*

B

6.CHECK CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.

for LHD:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM

for RHD:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output (for LHD) B
CAN communication system DTCs are output (for RHD) C



A

7.PROBLEM SYMPTOMS TABLE

B

C

7.PROBLEM SYMPTOMS TABLE
a.

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

8.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

8.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

9.ADJUST, REPAIR OR REPLACE
9.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

10.CONFIRM TEST
10.CONFIRM TEST
Result:
Proceed to
NEXT



NEXT

END

11.CHECK ANTI-LOCK BRAKE SYSTEM
a.

Use the GTS to check if the anti-lock brake system is functioning normally.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Anti-lock brake system DTCs are not output A
Anti-lock brake system DTCs are output B



A

5.CHECK METER/GAUGE SYSTEM*

B