Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM33J0E _54 Brake _038477 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0192390 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  U0073  Control Module Communication Bus OFF  U0114  Lost Communication with 4WD Control ECU  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives signals from the 4 wheel drive control ECU via the CAN communication system.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0073 Control Module Communication Bus OFF The condition that the bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession while the voltage at the IG1 terminal is between 10 and 17.4 V. (Sent signals cannot be received.) CAN communication system
U0114 Lost Communication with 4WD Control ECU The CAN signal from the 4 wheel drive control ECU is lost or malfunctioning for 1 second.
·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

4 wheel drive control ECU



PROCEDURE

1.CHECK IF EACH ECU CONNECTOR IS SECURELY CONNECTED
a.

Turn the ignition switch off.


b.

Check if 4 wheel drive control ECU or skid control ECU (brake actuator assembly) is securely connected.

OK:

Each connector is securely connected.



Result:
Proceed to
OK
NG



OK

2.RECONFIRM DTC

NG

CONNECT CONNECTOR TO EACH ECU CORRECTLY

2.RECONFIRM DTC
a.

Turn the ignition switch off.


b.

Record the output DTCs (for ABS and CAN communication).

for ABS: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR

for CAN communication system for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM

for CAN communication system for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
HINT:

If the CAN communication system DTC and the relevant sensor DTCs are output simultaneously, troubleshoot the relevant sensor DTCs (for ABS) after the CAN communication system returns to normal.


Result:
Result Proceed to
DTC (relating to CAN communication system) is output A
DTC (relating to ABS) is output B
DTC is not output C




A

B

C