Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)
RM33J0E _56 Audio / Visual / Telematics _038485 AUDIO / VIDEO _0193314 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Dimmer Signal Circuit  


DESCRIPTION

The combination meter assembly sends an auto dimmer signal to the radio receiver assembly via this circuit.

When the radio receiver assembly receives an auto dimmer signal from the combination meter assembly, the panel switch of the radio receiver assembly dims and the screen changes to the night screen.

WIRING DIAGRAM

E314785E11
4.958,1.813 6.615,2.146 1.656,0.333 10 false G113 4.958,1.969 6.615,2.302 1.656,0.333 10 false Radio Receiver Assembly 5.24,1.031 6.896,1.365 1.656,0.333 10 false ADIM 5.021,0.938 6.677,1.271 1.656,0.333 10 false 3 1.573,1.042 3.229,1.375 1.656,0.333 10 false ACAN 2.094,0.917 3.75,1.25 1.656,0.333 9 false 4 0.844,1.781 2.5,2.115 1.656,0.333 10 false G9 0.844,1.938 2.75,2.375 1.906,0.438 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, make sure to replace it with a new one.


PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY
a.
E140414C57
1.521,0.438 1.969,0.646 0.448,0.208 1.052,1.375 0.667,1.031 0.667,1.031 0.5,1.031 true 0.115,0.094 0.427,0.25 0.313,0.156 10 false *a 0.115,0.927 0.729,1.125 0.615,0.198 10 false ADIM 1.573,0.458 2.031,0.656 0.458,0.198 10 false G113
*a Front view of wire harness connector
(to Radio Receiver Assembly)


Disconnect the radio receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G113-3 (ADIM) - Body ground Ignition switch ON, automatic light control sensor covered by hand, and light control switch in tail or head position 9 V or higher



Result:
Proceed to
OK
NG



OK

NG

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the G113 radio receiver assembly connector.


b.

Disconnect the G9 combination meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G113-3 (ADIM) - G9-4 (ACAN) Always Below 1 Ω
G113-3 (ADIM) or G9-4 (ACAN) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR