Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89782
1.INSPECT TRANSPONDER KEY COIL (IGNITION KEY CYLINDER LIGHT)
| *a | Component without harness connected
(Transponder Key Coil (Ignition Key Cylinder Light)) |
Apply battery voltage to the connector and check the light illumination condition.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 2 (ILL+)
Battery negative (-) → Terminal 4 (ILL-) |
Illuminates |
If the result is not as specified, replace the transponder key coil (ignition key cylinder light).