Home › General › SPECIFICATIONS › LIGHTING (INT)
RM33J0E _V1 General _038516 SPECIFICATIONS _0178240 LIGHTING (INT) F

SPECIFICATIONS  LIGHTING (INT)  SERVICE DATA  


PERSONAL LIGHT
Connector Condition Tester Connection Condition Specified Condition
Component without harness connected 2 (B) - 1 (GND) (w/o Microphone)
5 (B) - 3 (GND) (w/ Microphone)
Map light switch LH OFF, RH OFF 10 kΩ or higher
Map light switch LH ON, RH OFF Below 1 Ω
Map light switch LH ON, RH ON Below 1 Ω
Map light switch LH OFF, RH ON Below 1 Ω
2 (B) - 3 (CTY) (w/o Microphone)
5 (B) - 1 (CTY) (w/ Microphone)
Courtesy switch OFF position 10 kΩ or higher
Courtesy switch DOOR position Below 1 Ω
A15 (MACC) - B5 (MACC) Always Below 1 Ω
A14 (MCO+) - B3 (MIC+) Below 1 Ω
A13 (MCO-) - B2 (MIC-) Below 1 Ω

FRONT DOOR COURTESY SWITCH (for Double Cab)
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected Terminal 1 - Switch body Pushed 5 MΩ or higher
Not pushed Below 20 Ω

FRONT DOOR COURTESY SWITCH (for Single Cab)
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected Terminal 1 - Switch body Pushed 5 MΩ or higher
Not pushed Below 20 Ω

FRONT DOOR COURTESY SWITCH (for Smart Cab)
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected Terminal 1 - Switch body Pushed 5 MΩ or higher
Not pushed Below 20 Ω

REAR DOOR COURTESY SWITCH (for Double Cab)
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected Terminal 1 - Switch body Pushed 5 MΩ or higher
Not pushed Below 20 Ω

RELAY
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω