1.CONNECT WASHER HOSE
Attach the clamp to connect the washer hose.
85035
2.INSTALL WASHER NOZZLE SUB-ASSEMBLY
76183
3.INSTALL NO. 1 HOOD BULGE PROTECTOR (w/ Hood Bulge)
Clean the No. 1 hood bulge protector installation surface with a non-residue solvent.
Apply primer to the No. 1 hood bulge protector installation area on the hood bulge.
Apply primer evenly so that there are no uncoated areas.
Remove the peeling paper on a new No. 1 hood bulge protector while making sure not to touch the adhesional surface.
| A | 0 to 2.0 mm |
Install a new No. 1 hood bulge protector to the hood bulge.
Remove the peeling paper from double-sided tape and press the double-sided tape to the side of the hood bulge.
Install a new No. 1 hood bulge protector in the position shown in the illustration.
Press the double-sided tape on the No. 1 hood bulge protector firmly to attach.
After the primer dries (3 minutes or more), install the No. 1 hood bulge protector.
After applying primer, reapply primer after 24 hours elapse.
76181
4.INSTALL HOOD BULGE (w/ Hood Bulge)
Attach the clip to install the hood bulge with the 11 nuts.
76186
5.INSTALL HOOD AIR INTAKE SEAL (w/ Hood Bulge)
Attach the clip to install the hood air intake seal.
53341B
6.INSTALL HOOD INSULATOR
w/ Hood Bulge:
Attach the guide to install the hood insulator with 10 new clips.
w/ Hood Insulator:
Attach the guide to install the hood insulator with 12 new clips.
53381
7.INSTALL HOOD TO RADIATOR SUPPORT SEAL
Install the hood to radiator support seal with the 6 clips.
75770
8.INSTALL FRONT HOOD MOULDING ASSEMBLY
75777E
9.INSTALL FRONT HOOD MOULDING PAD
85035
10.INSPECT WASHER NOZZLE SUB-ASSEMBLY
for LHD:
Click hereVehicle Exterior>WIPER / WASHER>WASHER NOZZLE>ON-VEHICLE INSPECTION
for RHD:
Click hereVehicle Exterior>WIPER / WASHER>WASHER NOZZLE>ON-VEHICLE INSPECTION
85035
11.ADJUST WASHER NOZZLE SUB-ASSEMBLY