Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM33J0E _59 Vehicle Exterior _038509 WIPER / WASHER _0193637 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  REMOVAL  


PROCEDURE

Hide 1.DRAIN WASHER FLUID

a.
B400509C01
1.74,2.104 2,2.375 0.26,0.271 10 false 90°
V100135

Turn in this Direction


Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.


b.

for 2WD Model:

i.
B400404C01
0,0 0,0 false
V100135

Screw
V100136

Clip
V113147

Slide in this Direction


Remove the 3 screws.


ii.

Remove the 9 clips.


iii.

Slide the front fender liner LH toward the rear of the vehicle and down to create a clearance as shown in the illustration.



c.

for 4WD Model, for Prerunner Model:

i.
B400445C01
0,0 0,0 false
V100135

Screw
V100136

Clip
V113147

Slide in this Direction


Remove the 3 screws.


ii.

Remove the 11 clips.


iii.

Slide the front fender liner LH toward the rear of the vehicle and down to create a clearance as shown in the illustration.



d.
B400406

Disconnect the washer hose and drain the washer fluid.

NOTICE:

Prepare a container before performing the procedure.



Hide 85310 2.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
B400408C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Pull as shown in the illustration to remove the windshield washer motor and pump assembly.


Hide 85301 3.REMOVE WASHER INLET SUB-ASSEMBLY

a.
B400410C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and guide and remove the washer inlet sub-assembly.


Hide 85330 4.REMOVE WINDSHIELD WASHER JAR ASSEMBLY

a.
B400412

Detach the clamp.


b.

Remove the 3 bolts and windshield washer jar assembly.