Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM33J0E _58 Vehicle Interior _038504 HEATING / AIR CONDITIONING _0193639 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  IG Power Source Circuit  


DESCRIPTION

The main power source is supplied to the air conditioning amplifier assembly when the engine switch is on (IG).

The power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E315724E03
5.083,1.74 5.542,1.938 0.458,0.198 10 false G33 5.083,1.906 6.646,2.354 1.563,0.448 10 false Air Conditioning Amplifier Assembly 5.563,0.563 6.021,0.76 0.458,0.198 10 false IG+ 5.563,1.281 6.021,1.479 0.458,0.198 10 false GND 5.229,1.167 5.688,1.365 0.458,0.198 10 false 14 5.292,0.469 5.75,0.667 0.458,0.198 10 false 1 3.979,0.74 4.938,1.021 0.958,0.281 10 false IG1 NO.4 1.354,0.552 3.594,1.104 2.24,0.552 10 false from IG1 NO.1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND)
a.
E269948C33
1.448,0.333 1.958,0.583 0.51,0.25 3.01,0.823 2.76,0.823 2.76,0.823 2.656,1.25 true 0.927,0.479 1.177,0.479 1.177,0.479 1.375,1.26 true 0.042,0.052 0.354,0.25 0.313,0.198 10 false *a 1.573,0.375 1.885,0.573 0.313,0.198 10 false G33 3.073,0.75 3.406,0.948 0.333,0.198 10 false IG+ 0.594,0.417 1.104,0.604 0.51,0.188 10 false GND
*a Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G33-14 (GND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G33-1 (IG+) - Body ground Engine switch off Below 1 V
G33-1 (IG+) - Body ground Engine switch on (IG) 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR