Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)
RM33J0E _58 Vehicle Interior _038504 HEATING / AIR CONDITIONING _0193639 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when the engine switch is off. The power is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E315724E04
5.083,1.74 5.542,1.938 0.458,0.198 10 false G33 5.083,1.927 6.646,2.375 1.563,0.448 10 false Air Conditioning Amplifier Assembly 5.563,0.563 6.021,0.76 0.458,0.198 10 false B 5.563,1.281 6.021,1.479 0.458,0.198 10 false GND 5.229,1.167 5.688,1.365 0.458,0.198 10 false 14 5.25,0.469 5.708,0.667 0.458,0.198 10 false 21 3.917,0.74 4.875,1.021 0.958,0.281 10 false ECU-B NO.3 1.854,0.563 3.042,0.927 1.188,0.365 10 false from Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND)
a.
E269948C34
1.448,0.333 1.958,0.583 0.51,0.25 3.052,1.802 2.802,1.802 2.802,1.802 2.667,1.458 true 0.927,0.479 1.177,0.479 1.177,0.479 1.375,1.26 true 0.042,0.052 0.354,0.25 0.313,0.198 10 false *a 1.573,0.375 1.885,0.573 0.313,0.198 10 false G33 3.094,1.719 3.396,1.917 0.302,0.198 10 false B 0.594,0.417 1.104,0.604 0.51,0.188 10 false GND
*a Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly)


Disconnect the air conditioning amplifier assembly connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G33-14 (GND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G33-21 (B) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR