Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › ACCELERATOR PEDAL
RM33J0E _51 Engine / Hybrid System _038454 2TR-FE ENGINE CONTROL _0193663 ACCELERATOR PEDAL G

2TR-FE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Accel Sensor Out No. 1, Accel Sensor Out No. 2.

Powertrain > Engine > Data List
Tester Display
Accel Sensor Out No.1
Accel Sensor Out No.2
50003 234 280,281

e.

When depressing or releasing the accelerator pedal, check that the values of Accel Sensor Out No. 1 and Accel Sensor Out No. 2 are within the specification.

Standard Voltage:
Item Condition Specified Condition
Accel Sensor Out No. 1 Released 0.5 to 1.1 V
Depressed 2.6 to 4.5 V
Accel Sensor Out No. 2 Released 1.2 to 2.0 V
Depressed 3.4 to 4.75 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.