Home › Engine / Hybrid System › 1GD-FTV STARTING › GLOW PLUG
RM33J0E _51 Engine / Hybrid System _038427 1GD-FTV STARTING _0193845 GLOW PLUG A

1GD-FTV STARTING  GLOW PLUG  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
A343692

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

·

Make sure to wear protective gloves when performing work to avoid burns.



NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Common rail assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

Fuel inlet pipe sub-assembly



·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.

·

The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.

·

Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve or fuel pressure sensor, etc.

·

Make sure foreign matter does not enter the fuel path.



PROCEDURE

Hide 1. WARM UP ENGINE

CAUTION:

To protect the glow plug assembly from damage, before removing the glow plug assembly, make sure to warm up the engine.


Hide 23810A 2.REMOVE COMMON RAIL ASSEMBLY

Hide 19871 3.REMOVE NO. 1 GLOW PLUG CONNECTOR

CAUTION:

Make sure to wear protective gloves when performing work to avoid burns.


a.
A346967

Using an E8 "TORX" socket wrench, remove the stud bolt from the intake manifold.


b.
A346968

Remove the 4 glow plug screw grommets.


c.
A346969

Remove the 4 nuts and No. 1 glow plug connector.


Hide 19850 4.REMOVE GLOW PLUG ASSEMBLY

CAUTION:

Make sure to wear protective gloves when performing work to avoid burns.


a.
A346970

Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.