84450
1.INSPECT IGNITION SWITCH ASSEMBLY
| *a | Component without harness connected
(Ignition Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| - | LOCK | 10 kΩ or higher |
| 7 (ACC) - 5 (AM1) | ACC | Below 1 Ω |
| 8 (IG1) - 5 (AM1)
7 (ACC) - 5 (AM1) 4 (AM2) - 3 (IG2) |
ON | Below 1 Ω |
| 8 (IG1) - 5 (AM1)
6 (ST1) - 5 (AM1) 4 (AM2) - 3 (IG2) 4 (AM2) - 2 (ST2) |
START | Below 1 Ω |
If the result is not as specified, replace the ignition switch assembly.