Home › Engine / Hybrid System › 2GD-FTV STARTING › GLOW PLUG CONTROLLER
RM33J0E _51 Engine / Hybrid System _038444 2GD-FTV STARTING _0193856 GLOW PLUG CONTROLLER A

2GD-FTV STARTING  GLOW PLUG CONTROLLER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 28551 3.REMOVE GLOW PLUG CONTROLLER

A346978

a.

Disconnect the 4 connectors and detach the clamp from the glow plug controller.


b.
A346979

Remove the bolt and glow plug controller.


Hide 28559 4.REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.


Hide 28559A 5.REMOVE NO. 2 GLOW PLUG CONTROLLER BRACKET

a.

Remove the 2 screws and No. 2 glow plug controller bracket from the glow plug controller.