Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
86140A
1.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)
|
Install in this Direction |
Insert the radio receiver assembly in the direction of the arrow shown in the illustration to install it.
86212
2.INSTALL NO. 2 RADIO BRACKET (for Radio and Display Type)
Install the No. 2 radio bracket to the radio receiver assembly with the 3 screws.
Install the 2 screws.
86211
3.INSTALL NO. 1 RADIO BRACKET (for Radio and Display Type)
Install the No. 1 radio bracket to the radio receiver assembly with the 3 screws.
Install the 2 screws.
86140A
4.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
Connect all the connectors.
|
Place Hands Here |
Insert the radio receiver assembly with bracket to attach the clips on its backside.
When inserting the radio receiver assembly, do not press the knobs on it.
Install the radio receiver assembly with bracket with the 4 screws.
86120
5.INSTALL RADIO RECEIVER ASSEMBLY (for Radio Receiver Type)
|
Install in this Direction |
Insert the radio receiver assembly in the direction of the arrow shown in the illustration to install it.
86212
6.INSTALL NO. 2 RADIO BRACKET (for Radio Receiver Type)
Install the No. 2 radio bracket to the radio receiver assembly with the 3 screws.
Install the 2 screws.
86211
7.INSTALL NO. 1 RADIO BRACKET (for Radio Receiver Type)
Install the No. 1 radio bracket to the radio receiver assembly with the 3 screws.
Install the 2 screws.
86120
8.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
Connect all the connectors.
|
Place Hands Here |
Insert the radio receiver assembly with bracket to attach the clips on its backside.
When inserting the radio receiver assembly, do not press the knobs on it.
Install the radio receiver assembly with bracket with the 4 screws.
55900
9.INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
55909A
10.CONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
55908A
11.CONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
55906A
12.CONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
84013A
13.INSTALL INTEGRATION PANEL SUB-ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Manual Air Conditioning System)
55918A
14.INSTALL AIR INLET DAMPER CONTROL LEVER (for Manual Air Conditioning System)
55905J
15.INSTALL CONTROL KNOB SUB-ASSEMBLY (for Manual Air Conditioning System)
55410C
16.INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55041B
17.INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
55470
18.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
45100
19.INSTALL STEERING WHEEL ASSEMBLY
20.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).