Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER(for Double Cab)
RM33J0E _56 Audio / Visual / Telematics _038485 AUDIO / VIDEO _0193908 REAR DOOR SPEAKER(for Double Cab) A

AUDIO / VIDEO  REAR DOOR SPEAKER(for Double Cab)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 86160B 1.INSTALL REAR SPEAKER ASSEMBLY

a.

Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.


b.
E322685

Using an air riveter or hand riveter, install the rear speaker assembly with 3 new rivets.

NOTICE:
·
B171664C17
1.229,1.104 1.083,1.635 1.083,1.635 1.24,2.198 false 1.083,1.635 0.813,1.635 false 1.792,0.896 2.031,1.635 2.031,1.635 1.771,2.531 false 2.031,1.635 2.313,1.635 false 2.26,0.604 2.521,0.802 0.26,0.198 10 *a 2.26,2.448 2.563,2.677 0.302,0.229 10 *b 2.344,1.563 2.594,1.781 0.25,0.219 10 *1 0.594,1.573 0.844,1.75 0.25,0.177 10 *2
*a INCORRECT
*b CORRECT
*1 Mandrel
*2 Riveter


Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

·
B172390C19
0.719,0.115 1.021,0.115 false 0.813,1.146 1.01,1.146 false 0.813,2.438 1.01,2.438 false 2.313,0.573 2.542,0.781 0.229,0.208 10 false *a 2.313,2.76 2.552,2.958 0.24,0.198 10 false *b 1.052,2.365 1.313,2.583 0.26,0.219 10 false *1 2.323,1.573 2.583,1.781 0.26,0.208 10 false *a 1.052,1.073 1.292,1.25 0.24,0.177 10 false *1 1.042,0.031 1.292,0.229 0.25,0.198 10 false *1
*a INCORRECT
*b CORRECT
*1 Riveter


Confirm that the rivets are seated properly against the speaker.

·

Do not tilt the riveter when installing the rivet to the speaker.

·

Do not leave any space between the rivet head and speaker.

·
B172391C18
0.74,0.646 0.938,0.646 false 0.729,2.156 0.938,2.156 false 2.292,1.042 2.615,1.271 0.323,0.229 10 *a 2.302,2.458 2.625,2.667 0.323,0.208 10 *b 0.958,0.552 1.229,0.719 0.271,0.167 10 *1 0.958,2.073 1.271,2.24 0.313,0.167 10 *1
*a INCORRECT
*b CORRECT
*1 Riveter


Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.




c.

Connect the connector.


Hide 67604 2.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 69284D 3.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 4.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 74260 5.INSTALL REAR ARMREST ASSEMBLY LH

Hide 67674A 6.INSTALL REAR DOOR FRAME GARNISH LH

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).