Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89782
1.INSTALL TRANSPONDER KEY COIL
Connect the connector.
|
Install in this Direction |
Align the claws of the transponder key coil with the upper bracket.
Push in the transponder key coil and install it to the upper bracket.
Do not push in the amplifier with excessive force as it may be damaged.
45286B
2.INSTALL STEERING COLUMN UPPER COVER
45287
3.INSTALL STEERING COLUMN LOWER COVER
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).