Home › Steering › STEERING COLUMN › STEERING PAD SWITCH
RM33J0E _55 Steering _038483 STEERING COLUMN _0193968 STEERING PAD SWITCH A

STEERING COLUMN  STEERING PAD SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the upper instrument panel removal/installation are shown below.

CAUTION:
B403904

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing.

for Type A: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45130 2.REMOVE STEERING WHEEL PAD ASSEMBLY

Hide 84250A 3.REMOVE STEERING PAD SWITCH ASSEMBLY

a.

Disconnect the connectors from the spiral cable sub-assembly.


b.
C330551

Remove the 2 screws.


c.

Detach the 6 guide pins and 2 claws to remove the steering pad switch assembly.