Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.SECURE STEERING WHEEL ASSEMBLY
Secure the steering wheel assembly with the seat belt in order to prevent rotation.
This operation is useful to prevent damage to the spiral cable sub-assembly.
3.REMOVE FRONT WHEELS
51410
4.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)
51442
5.REMOVE NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)
51405D
6.REMOVE ENGINE UNDER BRACE SUB-ASSEMBLY (for 2WD)
Remove the 8 bolts and 2 engine under brace sub-assemblies.
45058A
7.REMOVE NO. 1 RACK BOOT PROTECTOR SUB-ASSEMBLY (for 2WD)
Remove the 2 bolts and 2 rack boot protector sub-assemblies.
45047
8.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
Remove the cotter pin and nut.
| *a | Hold |
| *b | Turn |
Using SST, disconnect the tie rod end sub-assembly LH from the front axle hub assembly LH.
45046
9.DISCONNECT TIE ROD END SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
45219
10.DISCONNECT STEERING SLIDING YOKE
| *a | Matchmark |
Place matchmarks on the steering sliding yoke and No. 2 steering intermediate shaft sub-assembly.
Loosen the bolt labeled A.
Remove the bolt labeled B.
|
Install in this Direction |
Disconnect the steering sliding yoke from the No. 2 steering intermediate shaft sub-assembly.
45203
11.REMOVE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
| *a | Matchmark |
Place matchmarks on the No. 2 steering intermediate shaft sub-assembly and power steering link assembly.
|
Install in this Direction |
Remove the bolt and No. 2 steering intermediate shaft sub-assembly from the power steering link assembly.
If the No. 2 steering intermediate shaft sub-assembly is struck, replace it with a new one.
41110F
12.REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD)
13.REMOVE POWER STEERING LINK ASSEMBLY (for 2WD)
Using a union nut wrench, loosen the flare nut and disconnect the pressure feed tube assembly.
Remove the bolt and disconnect the pressure feed tube assembly bracket from the power steering link assembly.
Slide the clip and disconnect the return hose.
Using a union nut wrench, disconnect the steering gear outlet return tube.
|
Remove in this Direction |
Fix the 2 nuts in place and remove the 2 bolts and 2 washers. Then remove the power steering link assembly from the front suspension member.
Never turn the nut. Be sure to turn the bolt.
14.REMOVE POWER STEERING LINK ASSEMBLY (for 4WD and Pre-Runner)
Using a union nut wrench, loosen the flare nut and disconnect the pressure feed tube assembly.
Remove the bolt and disconnect the pressure feed tube assembly bracket from the power steering link assembly.
Slide the clip and disconnect the return hose.
Using a union nut wrench, disconnect the steering gear outlet return tube.
|
Remove in this Direction |
Fix the 2 nuts in place and remove the 2 bolts and 2 washers. Then remove the power steering link assembly from the front suspension member.
Never turn the nut. Be sure to turn the bolt.