Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM33J0E _55 Steering _038484 STEERING GEAR / LINKAGE _0193969 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.INSPECT TIE ROD END SUB-ASSEMBLY

a.
C322200

Move the ball joint stud back and forth 5 times as shown in the illustration, before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

0.5 to 3.5 N*m (6 to 35 kgf*cm, 5 to 30 in.*lbf)


If the turning torque is not within the specified range, replace the tie rod end sub-assembly with a new one.


Hide 2.INSPECT POWER STEERING LINK ASSEMBLY

a.
C327830N01
1.771,0.292 2.104,0.417 false 1.49,0.208 1.948,0.406 0.458,0.198 10 false SST

Using SST, check that the steering rack boots stretches smoothly when the control valve shaft is being rotated.

SST
09616-00011  

If there is any abnormality, replace the steering rack end boots with a new one.