Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(w/o Turn Over)
RM33J0E _52 Drivetrain _038465 CLUTCH _0193973 CLUTCH MASTER CYLINDER(w/o Turn Over) A

CLUTCH  CLUTCH MASTER CYLINDER(w/o Turn Over)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DRAIN CLUTCH FLUID

NOTICE:

Wash off clutch fluid immediately if it comes into contact with a painted surface.


Hide 31434 2.DISCONNECT CLUTCH RESERVOIR TUBE

a.
C333654

Slide the clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 31481 3.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C333655

Using a union nut wrench, disconnect the clutch master cylinder to flexible hose tube.

HINT:

Use a container to collect the fluid.



Hide 4.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

Hide 31410 5.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C324306

Remove the 2 nuts, clutch master cylinder assembly and gasket.


Hide 6.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the lock nut, and then remove the master cylinder push rod clevis and lock nut from the push rod.

NOTICE:

When loosening the lock nut, be sure to hold the clevis in place by its square portion.