Home › Drivetrain › CLUTCH › CLUTCH UNIT(for RC60, RC61)
RM33J0E _52 Drivetrain _038465 CLUTCH _0193977 CLUTCH UNIT(for RC60, RC61) G

CLUTCH  CLUTCH UNIT(for RC60, RC61)  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

a.
C322136

Using a vernier caliper, measure the rivet head depth.

Minimum rivet head depth:

0.3 mm (0.0118 in.)


If the depth is less than the minimum, replace the clutch disc assembly.


b.
C322137

Using a dial indicator, check the disc runout.

Maximum runout:

0.8 mm (0.0314 in.)


NOTICE:

Be sure to measure on the correct side of the clutch disc.


If the runout is more than the maximum, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

a.
C322138C01
0.865,0.271 1.177,0.469 0.313,0.198 10 false *a 0.198,0.573 0.51,0.771 0.313,0.198 10 false *b
*a Width
*b Depth


Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

Maximum width:

6.0 mm (0.236 in.)


Maximum depth:

0.35 mm (0.0137 in.)


If the depth or width is more than the maximum, replace the clutch cover assembly.


Hide 13405 3.INSPECT FLYWHEEL SUB-ASSEMBLY

a.
Q007250

Using a dial indicator, measure the flywheel runout.

Maximum runout:

0.1 mm (0.00393 in.)


If the runout is more than the maximum, replace the flywheel sub-assembly.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

a.
N000414

Turn the bearing by hand while applying force in the axial direction and check that the bearing rotates smoothly.

If the bearing sticks or a considerable amount of resistance is felt, replace the release bearing.

HINT:

The bearing is permanently lubricated and requires no cleaning or lubrication.



Hide 33311A 5.INSPECT INPUT SHAFT FRONT BEARING

a.
C322148

Turn the bearing by hand while applying rotational force and check that the bearing rotates smoothly.

If the bearing sticks or a considerable amount of resistance is felt, replace the input shaft front bearing.

HINT:

The bearing is permanently lubricated and requires no cleaning or lubrication.



Hide 33311A 6.REPLACE INPUT SHAFT FRONT BEARING

a.

Remove any 2 diametrically opposite bolts.


b.
C322149N01
1.052,0.917 1.385,0.354 true 1.385,0.167 1.844,0.365 0.458,0.198 10 false SST

Using SST, remove the input shaft front bearing.

SST
09303-35011  


c.
C322150N01
1.167,0.948 1.375,0.344 true 1.375,0.135 1.833,0.333 0.458,0.198 10 false SST

Using SST and a hammer, tap in a new input shaft front bearing.

SST
09304-12012  

HINT:

After installing the bearing to the crankshaft, make sure that it rotates smoothly.



d.

Apply adhesive to 2 or 3 threads of the bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



e.

Install the 2 bolts.

Torque:
178 N*m (1815 kgf*cm, 131 ft.*lbf)