Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE(for 2WD)
RM33J0E _54 Brake _038479 BRAKE (FRONT) _0193996 FRONT BRAKE FLEXIBLE HOSE(for 2WD) A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE(for 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 47313A 1.INSTALL FRONT FLEXIBLE HOSE

a.

Install a new gasket and connect the front flexible hose to the disc brake cylinder assembly LH with a new union bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


b.

Install a new clip to the front flexible hose.

NOTICE:

Make sure the clip is completely pushed in.



c.
A329093C03
1.719,0.542 2.031,0.698 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)



NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting point.




d.

Install the front flexible hose to the absorber bracket with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 2.BLEED BRAKE LINE (w/ VSC)

Hide 3.BLEED BRAKE LINE (w/o VSC)

Hide 4.BLEED CLUTCH LINE (for Manual Transmission)

Hide 5.INSTALL FRONT WHEEL