Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE(for 4WD and Pre-Runner)
RM33J0E _54 Brake _038479 BRAKE (FRONT) _0193997 FRONT BRAKE FLEXIBLE HOSE(for 4WD and Pre-Runner) A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 47313A 3.REMOVE FRONT FLEXIBLE HOSE

C323349

a.

Disconnect the brake line from the front flexible hose with a union nut wrench while holding the front flexible hose with a wrench.

NOTICE:
·

Do not bend or damage the brake tube.

·

Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.




b.

Remove the 2 clips and front flexible hose.


Hide 47343A 4.REMOVE FRONT NO. 1 WHEEL CYLINDER TUBE LH

C323350

a.

Using a union nut wrench, remove the front No. 1 wheel cylinder tube LH from the disc brake cylinder assembly LH.

NOTICE:
·

Do not bend or damage the front No. 1 wheel cylinder tube LH.

·

Do not allow any foreign matter such as dirt and dust to enter the front No. 1 wheel cylinder tube LH from the connecting points.