Home › Brake › BRAKE (REAR) › REAR BRAKE(for 4WD and Pre-Runner)
RM33J0E _54 Brake _038480 BRAKE (REAR) _0193999 REAR BRAKE(for 4WD and Pre-Runner) A

BRAKE (REAR)  REAR BRAKE(for 4WD and Pre-Runner)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.CHECK BRAKE SHOE LINING THICKNESS

C323376

a.

Remove the shoe inspection hole plug, and check the shoe lining thickness through the hole.

Minimum thickness:

1.0 mm (0.0394 in.)


If the thickness is less than the minimum, replace the brake shoe.


Hide 2.REMOVE REAR WHEEL

Hide 3.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 42403 4.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

a.

Release the parking brake lever, and remove the rear brake drum sub-assembly and brake drum gasket.

HINT:

If the rear brake drum sub-assembly cannot be removed easily, perform the following procedures.



b.
C323377C01
1.688,1.323 2.271,1.323 true 0.969,1.198 0.969,0.781 0.969,0.781 0.729,0.781 true 0.521,0.698 0.719,0.875 0.198,0.177 10 true *1 2.292,1.24 2.49,1.417 0.198,0.177 10 true *2
*1 Automatic Adjust Lever
*2 Brake Shoe Adjuster


Remove the shoe adjusting hole plug and insert a screwdriver into the hole on the backing plate, and hold the automatic adjust lever away from the adjuster.


c.

Using another screwdriver, compress the brake shoe adjuster by turning the adjusting wheel.