Home › Engine / Hybrid System › 1KD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM33J0E _51 Engine / Hybrid System _038428 1KD-FTV ENGINE CONTROL _0195861 CRANKSHAFT POSITION SENSOR G

1KD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11301L 1.INSPECT CRANKSHAFT POSITION SENSOR

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 1630 to 2740 Ω
1 - 2 Hot 2065 to 3225 Ω


NOTICE:

In the chart above, the terms "cold" and "hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the crankshaft position sensor.