Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › ACCELERATOR PEDAL
RM33J0E _51 Engine / Hybrid System _038420 1GD-FTV ENGINE CONTROL _0195869 ACCELERATOR PEDAL A

1GD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal sensor assembly.

If applied, the accelerator pedal sensor assembly must be replaced.


a.

Install the accelerator pedal sensor assembly with the 2 nuts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:
·

Avoid physical shocks to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.




b.

Connect the accelerator pedal sensor connector.