Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › DIESEL THROTTLE BODY
RM33J0E _51 Engine / Hybrid System _038446 2KD-FTV ENGINE CONTROL _0195893 DIESEL THROTTLE BODY A

2KD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the diesel throttle body assembly removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of diesel throttle body assembly Perform initialization - (Click here)

PROCEDURE

Hide 17806 1.REMOVE NO. 1 INTAKE PIPE

a.
A111789

Disconnect the manifold absolute pressure sensor connector.


b.

Disconnect the vacuum hose from the gas filter.


c.

Loosen the 2 hose clamps.


d.

Remove the bolt and disconnect the No. 1 intake pipe together with the No. 1 air hose and No. 2 air hose.


Hide 26100G 2.REMOVE DIESEL THROTTLE BODY ASSEMBLY

a.
A197475

Disconnect the diesel throttle body 2 connectors.


b.
A253472

Remove the 2 bolts, 2 nuts and the diesel throttle body assembly.


c.

Remove the gasket from the intake air connector.