Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › ACCELERATOR PEDAL
RM33J0E _51 Engine / Hybrid System _038446 2KD-FTV ENGINE CONTROL _0195895 ACCELERATOR PEDAL G

2KD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78120G 1.INSPECT ACCELERATOR PEDAL SENSOR

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

Powertrain > Engine > Data List
Tester Display
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
50003 234 15,16

e.

Operate the accelerator pedal rod and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.

If the result is not as specified, refer to DTC P2120.

Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM>P2120