Home › Engine / Hybrid System › 1KD-FTV FUEL › FUEL SUPPLY PUMP
RM33J0E _51 Engine / Hybrid System _038430 1KD-FTV FUEL _0196041 FUEL SUPPLY PUMP G

1KD-FTV FUEL  FUEL SUPPLY PUMP  INSPECTION  


PROCEDURE

Hide 22100 1.INSPECT FUEL SUPPLY PUMP ASSEMBLY

a.

Inspect the suction control valve.

i.
A347383C01
0.552,1.292 1.323,1.292 true 0.552,1.542 0.75,1.542 0.75,1.542 1.365,1.333 true 2.219,1.49 2.99,1.49 true 2.219,1.552 2.802,1.771 2.802,1.771 2.99,1.771 true 0.563,0.792 0.76,0.792 0.76,0.792 1.333,1.229 true 2.229,1.448 2.792,0.948 2.792,0.948 2.979,0.948 true 0.396,0.698 0.708,0.854 0.313,0.156 10 false *1 3.021,0.854 3.333,1.01 0.313,0.156 10 false *2 0.438,1.448 0.615,1.635 0.177,0.188 10 false 1 0.438,1.188 0.635,1.365 0.198,0.177 10 false 2 3.052,1.406 3.25,1.583 0.198,0.177 10 false 2 3.052,1.688 3.229,1.875 0.177,0.188 10 false 1
*1 Suction Control Valve
*2 Fuel Temperature Sensor


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 1.9 to 2.3 Ω


If the result is not as specified, replace the fuel supply pump assembly.



b.

Inspect the fuel temperature sensor.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.32 to 2.59 kΩ


If the result is not as specified, replace the fuel supply pump assembly.