16331A
1.INSTALL THERMOSTAT
| *1 | Gasket |
| *a | Jiggle Valve |
| *b | CORRECT |
| *c | INCORRECT |
|
Upward |
Install a new gasket to the thermostat.
When installing the gasket to the thermostat, be careful not to deform the gasket. Make sure that the groove of the gasket is properly installed to the thermostat, as shown in the illustration.
Insert the thermostat into the cylinder block with the jiggle valve facing straight upward.
The jiggle valve may be set within 30° of either side of the prescribed position.
16321
2.INSTALL WATER INLET
Install the water inlet with the 3 bolts.
Connect the wire harness with the bolt to the water inlet.
16572D
3.CONNECT NO. 2 RADIATOR HOSE
Connect the No. 2 radiator hose to the water inlet.
17701
4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
5.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17705
6.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE
12278
7.INSTALL PCV HOSE HEAT INSULATOR
8.ADD ENGINE COOLANT
9.INSPECT FOR COOLANT LEAK
51410
10.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)