Home › Drivetrain › VF2CM TRANSFER / 4WD / AWD › TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM
RM33J0E _52 Drivetrain _038470 VF2CM TRANSFER / 4WD / AWD _0197772 TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM T

VF2CM TRANSFER / 4WD / AWD  TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Touch Select 2-4 and High-low System
Symptom Suspected Area Link
While in 2WD, even when the transfer position switch is turned to a position other than H2, the 4WD indicator light (green) and 4LO indicator light do not illuminate ECU power source circuit Click here
CAN communication system Click here
Combination meter assembly
Transfer position switch
4 wheel drive control ECU
While in 4WD, even when the transfer position switch is turned to a position other than H4, the 4WD indicator light (green) remains on and the 4LO indicator light does not illuminate ECU power source circuit Click here
Clutch start switch circuit (for Manual Transmission) Click here
Transfer position switch Click here
4 wheel drive control ECU
While in 4WD, even when the transfer position switch is turned to a position other than L4, the 4WD indicator light (green) and 4LO indicator light remain illuminated ECU power source circuit Click here
Transfer position switch Click here
4 wheel drive control ECU
CAN communication system
The 4WD indicator light (green) continues blinking after the transfer position switch is operated ECU power source circuit Click here
Transfer shift actuator assembly (transfer shift motor) Click here
A.D.D. actuator (differential motor actuator assembly) (A.D.D. shift motor)*
Transfer shift actuator assembly (limit switch, 4WD detection switch or L4 detection switch)
A.D.D. actuator (differential motor actuator assembly) (limit switch or A.D.D. position switch)*
4 wheel drive control ECU
The 4LO indicator light continues blinking after the transfer position switch is operated ECU power source circuit Click here
Clutch start switch circuit (for Manual Transmission) Click here
Transfer shift actuator assembly (transfer shift motor) Click here
Transfer shift actuator assembly (limit switch, 4WD detection switch or L4 detection switch)
4 wheel drive control ECU

*: w/ A.D.D. Actuator


Blinking: Blinks at 0.5 second intervals (0.5 seconds on and 0.5 seconds off)