This DTC is output when a malfunction is detected due to a short to ground occurring in the differential lock coil drive circuit of the rear differential.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P17C0 | Rear Differential Lock Solenoid Circuit Low | ·
Diagnosis Condition: Directly after ignition switch is turned to ON, or when rear differential is switched between free and locked (differential lock coil operating) with ignition switch turned to ON ·
Malfunction Status: Short to ground in differential lock coil drive circuit ·
Malfunction Time: 0.05 seconds or more ·
Other: 1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Differential lock coil |
Disconnect the C40 4 wheel drive control ECU connector.
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C40-1 (SL+) or C40-5 (SL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the C40 4 wheel drive control ECU connector.
Disconnect the F1 differential lock coil connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C40-1 (SL+) or F1-2 (M1) - Body ground | Always | 10 kΩ or higher |
| C40-5 (SL-) or F1-1 (M2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG