Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY
RM33J0E _52 Drivetrain _038472 AXLE AND DIFFERENTIAL _0199118 REAR DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The following procedures are for BD20 (w/o Differential Lock).


PROCEDURE

Hide 41110 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Clean the contact surfaces of the rear differential carrier assembly and axle housing.


b.

Install the rear differential carrier assembly, a new rear differential carrier gasket and the washers with the 10 nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

CAUTION:

The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.


NOTICE:
·

Do not damage the installation surface when installing the rear differential carrier assembly.

·

The remaining oil may leak out when installing the rear differential carrier assembly.

·

Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

·

Install the bolts with the rear differential carrier assembly secured.




Hide 2.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH

Hide 3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 4.BLEED AIR FROM BRAKE LINE

Hide 7.ADJUST PARKING BRAKE