Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock)
RM33J0E _52 Drivetrain _038472 AXLE AND DIFFERENTIAL _0199119 REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock) A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY(w/ Differential Lock)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

The following procedures are for BD22 (w/ Differential Lock).


PROCEDURE

Hide 41110 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Clean the contact surfaces of the rear differential carrier assembly and axle housing.


b.

Install the rear differential carrier assembly and a new rear differential carrier gasket with the 10 nuts and 10 washers.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)

CAUTION:

The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.


NOTICE:
·

Do not damage the installation surface when installing the rear differential carrier assembly.

·

The remaining oil may leak out when installing the rear differential carrier assembly.

·

Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

·

Install the bolts with the rear differential carrier assembly secured.




c.

Connect the 2 connectors.


Hide 2.INSTALL DIFFERENTIAL PROTECTOR

a.

Install the differential protector with the 2 bolts.

Torque:
29.5 N*m (301 kgf*cm, 22 ft.*lbf)


Hide 3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH

Hide 4.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 8.ADJUST PARKING BRAKE