Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DECELERATION SENSOR(for 4WD and Pre-Runner without VSC)
RM33J0E _54 Brake _038477 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0199130 DECELERATION SENSOR(for 4WD and Pre-Runner without VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DECELERATION SENSOR(for 4WD and Pre-Runner without VSC)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 46334 4.REMOVE INTERMEDIATE LEVER PROTECTOR

Hide 89441A 5.REMOVE DECELERATION SENSOR

a.
C324731C01
2.719,1.292 3.083,1.292 3.083,1.292 3.083,2.01 true 3.031,2.052 3.292,2.25 0.26,0.198 10 true *1
*1 Fuel Lid Control Cable Clamp


Detach the fuel lid control cable clamp from the deceleration sensor.


b.

Disconnect the deceleration sensor connector.


c.

Remove the 2 bolts and deceleration sensor.