Home › Engine / Hybrid System › 1GD-FTV EMISSION CONTROL › EGR COOLER
RM33J0E _51 Engine / Hybrid System _038423 1GD-FTV EMISSION CONTROL _0201047 EGR COOLER A

1GD-FTV EMISSION CONTROL  EGR COOLER  INSTALLATION  


PROCEDURE

Hide 25681 1.INSTALL NO. 1 EGR COOLER

a.

Install a new gasket and the No. 1 EGR cooler to the No. 2 EGR valve assembly with electric EGR control valve assembly with the 4 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 2.INSTALL NO. 1 EGR COOLER AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY

a.

Temporarily install the No. 1 EGR cooler and No. 2 EGR valve assembly with electric EGR control valve assembly to the intake manifold with the 4 bolts.


b.
A346657N01
1.042,1.969 1.177,2.146 0.135,0.177 10 true 1 2.229,1.896 2.365,2.073 0.135,0.177 10 true 2 2.99,0.917 3.125,1.094 0.135,0.177 10 true 3 0.438,0.49 0.573,0.667 0.135,0.177 10 true 4

Tighten the 4 bolts in the order shown in the illustration.

NOTICE:

Make sure to tighten the bolts in the order.


Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 25804 3.INSTALL VACUUM CONTROL VALVE SET

Hide 25601 4.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY

Hide 16209 5.CONNECT NO. 4 WATER BY-PASS PIPE SUB-ASSEMBLY

Hide 16206B 6.INSTALL NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY

a.

Install the No. 3 water by-pass pipe sub-assembly to the No. 1 EGR cooler with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the No. 9 water by-pass hose to the electric EGR control valve assembly, and slide the clamp to secure the hose.


c.

Connect the No. 8 water by-pass hose to the No. 3 water by-pass pipe sub-assembly, and slide the clamp to secure the hose.


d.

Connect the No. 4 fuel hose to the No. 3 water by-pass pipe sub-assembly.


Hide 23300 10.CONNECT FUEL FILTER ASSEMBLY

Hide 12632 11.INSTALL NO. 2 ENGINE COVER BRACKET

Hide 44763C 12.INSTALL NO. 2 HOSE TO HOSE TUBE

Hide 89421C 13.INSTALL TURBO PRESSURE SENSOR

Hide 16278 15.INSTALL NO. 2 WATER BY-PASS PIPE

Hide 26100G 16.INSTALL DIESEL THROTTLE BODY ASSEMBLY