Home › Engine / Hybrid System › 2KD-FTV ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM33J0E _51 Engine / Hybrid System _038447 2KD-FTV ENGINE MECHANICAL _0201071 FRONT CRANKSHAFT OIL SEAL A

2KD-FTV ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11303A 1.INSTALL FRONT CRANKSHAFT OIL SEAL

a.

Apply MP grease to the lip of a new front crankshaft oil seal.

NOTICE:
·

Keep the lip free of foreign matter.

·

Do not allow MP grease to contact the dust seal.




b.
A352052N01
0.958,1.375 0.677,1.198 0.677,1.198 0.5,1.198 true 0.219,1.094 0.542,1.26 0.323,0.167 10 false SST

Using SST and a hammer, tap in the front crankshaft oil seal.

SST
09214-76011  

NOTICE:
·

The acceptable depth from the top of the timing chain cover is 0 to 1.0 mm (0 to 0.0394 in.)

·

Keep the lip free from foreign matter.

·

Do not tap the front crankshaft oil seal at an angle.

·

Make sure that the front crankshaft oil seal is properly installed.




Hide 13408 2.INSTALL CRANKSHAFT PULLEY SUB-ASSEMBLY

a.

Align the keyway of the crankshaft pulley with the key located on the crankshaft, and then slide the crankshaft pulley sub-assembly into place to install it.


b.
A352053C01
1.271,1.125 1.708,0.75 1.708,0.75 1.854,0.75 true 0.635,1.063 0.781,1.063 0.781,1.063 1.156,1.219 true 1.635,1.885 1.99,2.042 1.99,2.042 2.115,2.042 true 1.885,0.656 2.219,0.844 0.333,0.188 10 true SST 0.354,0.969 0.677,1.135 0.323,0.167 10 false SST 2.135,1.927 2.365,2.115 0.229,0.188 10 true *a
*a Hold
V100135

Turn


Using SST, install the crankshaft pulley bolt.

SST
09213-58014  (91551-80840)
09330-00021  

Torque:
365 N*m (3722 kgf*cm, 269 ft.*lbf)


Hide 16400 3.INSTALL RADIATOR ASSEMBLY